Learning how to caulk board and batten is not as difficult as you may think. It is important to understand the basics of how to properly install these materials. Many homeowners do not realize that when they install the roof they are also putting the panels into the ground. When drywall is laid in this manner, the boards separate from each other. This separation leaves a space for the flashing that will complete the installation of the drywall.
There are many different tools that are needed when learning how to caulk board and batten. Most home improvement stores carry all of the tools necessary to complete the job. Once you have the tools, it is time to start learning how to properly install the board. It is possible to complete the job without the help of a professional, but most people would prefer to have a professional to help them. The entire project will take several days to complete.
When learning how to caulk board and batten, it is important to keep a watch on the moisture that is inside of the area that is caulked. If the moisture levels get too high, the boards will become weak and even rip apart. In order to maintain a proper moisture level, you will want to monitor the outside and inside of the panels that are being caulked.
Once the drywall panels have been installed, then it is time to learn how to caulk board and batten the area completely. This means that you will want to wipe the board down very well with a very stiff bristled brush. Wipe the board down all around the perimeter of the area.
The final step in learning how to caulk board and batten is to put one end of the board on the surface of the wall that has been caulked. Then, take one end of the battening strip and align it with the board that has been attached to the wall. The board and strip should be centered so that they are exactly parallel. You will then take the other end of the strip and align it to the other board. Repeat the process until all of the areas of the wall that have been caulked are covered.
The final step in learning how to caulk board and batten is to fill the cracks that are found around the exterior of the home. The small holes will be filled with the caulk. This will help make the exterior of the home more attractive. The last step is to let the caulk dry overnight. You can sand the board down if you want some fine detail on the board but remember to allow for expansion as the dry material hardens.
